[Drills and Tappers] [Grinding-, Milling- and Polishing Machines] [Shears, Nibblers, Saws and Pliers] [Hammers, Scalers and Rammers]

Top-Speed-Grinder

Grinding and Milling with an actual speed of 100000 rpm

Optimum surface removal and surface quality by use of speed consistent gear drive
High repeatability by gear motor without vanes
Oilfree operation without loss of power
Best Ergonomic Shape
- Housing Grip
- Housing Material
- Noise Level
- Handling

High speed Midget Grinders, especially used with highgrade steel inserts at relative high speed are used for grinding, for deburring and also when treating non-metallic materials.
The technical solution to this was the miniature vane-motor with corresponding small power output, loss of speed when loaded and low durability or a turbine with additional gearing which is expensive and does not ofer a problem-free solution.
The

Top-Speed-Grinder with a modern gear motor brings all the advantages such as high power-output, consistent high-speed, robustness and oilfree use, without any of the previous mentioned disadvantages.
The best results when removing surfaces or when trying to obtain top surface quality depends primarily on the speed under load and the use of the best suited tooling. Compared to a vane motor, the advantage of this new high-speed gear-motor is in limiting the speed loss under power. The speed-loss of an already low-speed vane-motor amounts to about 50% under load, whereby the new gear-motor only looses about 30%. Because of the friction-less running of the motor-parts, the wear and tear is small.
An often exchange of vanes is a thing of the past!
The good material team-up of the drive also allows the oilfree operation, without the loss of power or speed.
The highly precise true running of our Top Form Grinders’ collets (<0.03 mm) thus clearly distinguishes these from our competitors’ equivalents; and it also positively affects the storing lifetime, the quality of the surface reached during grinding and milling as well as the tools’ vibration.
Independent from the technical data, the state-of-the-art ergonomic design contributes heavily to a positive production result. The asymmetric form allows an individual comfortable grip and a good orientation in the hand.
The twist-valve prevents a forced grip and conforms with its additional start-safety with the requirements on the EN 792.
The rear exhaust removes unpleasant exhaust air from the operator and the workstation. The integrated silencer reduces the noise level to a comfortable 72 dB(A).

Catalog D9120

PDF - Catalog : German

These products can also be found
on the Website of our quality mark

Cannot find what you are looking for?
Just contact one of our global partners -
we will find the solution for your problem!