[Handheld Screwdrivers] [Stationary Screwdriving Spindles] [Selection program: InsertingTools] [Measuring Technique]

Stationary Control Screwdriver Spindles

Torque range from 0.02 to 140 Nm / 0.2 to 1240 in.lbs
with integrated Function Control

The

- Control Screwdrivers assemble screws to torque and measure that torque more accurately than any subsequent testing. They tighten and test the assembly in one operation.

The screw joint, hard or soft, and air pressure fluctuations have no influence on the MICROMAT or MINIMAT clutch. The torque of the spindle can be pre set. Control Screwdrivers are available in right rotation, left rotation or reversible, with push to start or remote start option. These tools can be used without lubrication: This should however only be done in specific applications. Using a tool without lubrication will decrease it's lifespan.

The 5 available motor sizes with a minimum of 3 gear variations each, and the possibility to combine motorsize 2 and 3 drivers with off-set-/or reduction gearings off different gear ratio to minimize the center distance or to increase the torque value, fulfill a wide spectrum of requirements in regards to torqueand speed.