[Handheld Screwdrivers] [Stationary Screwdriving Spindles] [Selection program: InsertingTools] [Measuring Technique]
RECYCLING-Drivers
for the Dis-Assembly prior to Recycling
Especially when recycling electronic scrap material, a mechanical disassembly is required (i.e. loosening of screws) prior to the handling of chemical and thermal material.
The problem is:
- Engaging the screw drive with the bit.
- The required down-pressure right from the start, to avoid cam-out or ratcheting.
- A higher loosening torque and therefore backout-torque if screws are rusted, etc.
According to the required drive direction and the most positive support-grip, a technical clean solution is:
Horizontal Dis-Assembly:
- The pistolgrip driver, reversible, with trigger start and Quick Change Chuck, without clutch:
Maximum Torque: 10 Nm (89 in.lbs)
- Operation:
Set driver, engage bit, push trigger and tool will start.
- Backout torque reaction is easily absorbed by the pistol-grip form.
Vertical Dis-Assembly:
- The straight driver, reversible, with 2-stage push to start, left rotation safety-clutch and Quick Change Chuck:
Maximum Torque: 10 Nm (89 in.lbs)
- Operation:
Set driver, apply small down-pressure to engage bit with screw drive at reduced speed, apply full down-pressure and disassemble fastener.
- Backout torque reaction is limited by the adjustable safety-clutch.
The ERGONOMIC housing grip [oval shape] conforms with the Operators natural hand grip and easily absorbs the torque reaction force. Furthermore, the lower housing flares out [bell bottom] to simplify the required push-to start.
Cannot find what you are looking for?
Just contact one of our global partners -
we will find the solution for your problem!
Catalog D3530 
PDF - Catalog : German