[Handheld Screwdrivers] [Stationary Screwdriving Spindles] [Selection program: InsertingTools] [Measuring Technique]
EC-Electric Servo Screwdriver MINIMAT-E
The brushless, EC-electric Screwdriver (Angle Head Design)
for torque ranges of 7 – 60 Nm (62 – 531 in.lbs.)
The 
EC-Electric Servo Screwdriverallows the free programming of the screwtightening process. Within the performancerange of the Screwdriver, torque, speed, stand-by and turn-direction may be individually adapted to fit the required tightening process.
The integrated torque- and angle measurement permits the exact control and supervision of the tightening process, as well as the documentation of important processing parameters. Thus, the highest possible precision during the tightening process is guaranteed.
The brushless EC-motor is the reason for the maintenance-free operation, eliminating wear-and-tear parts. It also achieves a highmotor dynamics and is capable of reaching the necessary high peak-torque required for fastener tightening.
To operate the Screwdriver, a sequence controller (AST 30-31) with integrated power supply and a motor-cable is necessary. The motor-cable is available in different lengths.
The sequence controller already contains ready-to-use basic programs with common tightening processes, so that the operation can take place using just a few steps.This necessitates the connection to a standard PC with the supplied, very userfriendly Windows™-Software TC 30-PC. Current Software-Updates (Statistics, etc.) can be supplied as options on special request.
The integrated display- and operating key-pad visualizes the operating conditions and screwdriving results and it also allows the direct changing of screwdriving parameter (i.e. Speed, Shut-Off Torque) required for the production-process - without having a PC-connection.
Over the operating keypad or the I/O-port of the controller it is possible to change the two available default screwdriving programs. Once the cycle finishes, a status signal is optically displayed on the Screwdriver and also reported back to the PLC, if a PLC is used.
When using this EC-system with a PLC, then the communication can be made using the standard supplied Profibus port.
When using either bus-ports, Profibus or Ethernet (optional) and if those ports are connected with an IP-system, then the complete assembly process (screwdriving-curve, statistics, archiving) and the data-exchange between computers is possible.
When the Data Logger program (Optional Equipment) is used, it is possible to transfer the measuring data of several controllers to a PC using different ports (i.e. USB, Ethernet).
Cannot find what you are looking for?
Just contact one of our global partners -
we will find the solution for your problem!
Catalog D3497 
PDF - Catalog : German