[Handheld Screwdrivers] [Stationary Screwdriving Spindles] [Selection program: InsertingTools] [Measuring Technique]
MINIMAT™-Handheld Screwdrivers (straight handle design)
Torque: 0.2 - 20 Nm (2 - 177 in.lbs)
- Control Screwdrivers for the highest torque accuracy
- 19 different speeds
- All models have integrated Quick Change Chucks
- Ergonomically designed for long life and low noise
MINIMAT-ULTRA drivers with straight handle design are preferably used for vertical assemblies. As all the other tools in this series, the driver shuts-off with a high accuracy; independent of air pressure fluctuations or kind of screw joint.
For special cases e.g. assembly of spring clamps, screwdriver models with lever start are available.
The ergonomic design of the housing guarantees low fatigue operation. The available speeds and torque capacities enable the tools to adapt to any assembly requirement. Outstanding quality guarantees long life.
MINIMAT™-Handheld Screwdrivers (pistol-grip)
Torque: 0.3 - 24 Nm (3 - 212 in.lbs)
- accurate
- ergonomic
- long life expectancy
- low noise level
The pistol-grip screwdrivers are preferably used for horizontal screw assemblies.
The newly designed models with the prefix 347 are now available with an expanded torque range from 0.3 - 5 Nm (3 - 40 in.lbs). Those new pistolgrip drivers are smaller in size with a reduced weight. They incorporate advanced ergonomics and allow the possibility to choose between an air-inlet option from either below or from the top.
All design models incorporate the well-known characteristics of the MINIMAT-ULTRA series, where accuracy of the screwdriver is higher than any subsequent control method.
The preset torque remains constant, independent of hard- or soft pull-up joints and air pressure fluctuations.
The screwdriver is actuated by trigger. If needed, Exhaust Hoses can be connected to the screwdriver; this will direct exhaust air away from the assembly area.
For size 3 pistol-grip drivers, we offer additional side handles, which are useful addition for higher torque values.
MINIMAT™-Handheld Screwdrivers (angle-head design)
Torque range from 0.3 - 65 Nm / 2.7 - 575 in.lbs
- Extreme high Torque Accuracy and Repeatability
- For tight Assembly Areas
- Swivel Handle
- Ergonomic Design, long life, low noise
The 
- MINIMAT-ULTRA Screwdrivers with angle-head design are preferably used for assemblies in tight areas.
Because of the angle-head design even large torque values can be managed by hand without problems. With the two-motor drivers, screws can be tightened at high speed and then assembled to high torque by the use of the second motor.
The handle is linked with the angle head by a plug connection and can be arrested in different positions. The screwdriver with motor size 2 and 2.5 is a new development and has an optimized angle head which guarantees a very accurate torque transfer with little space required.
Cannot find what you are looking for?
Just contact one of our global partners -
we will find the solution for your problem!
Catalog D3430 
PDF - Catalog : German