DEPRAG Feed Module – DFM

For Assemblies on screw positions that are difficult to access

  • easy to operate
  • applies constant pressure
  • for hand guided nut assembly
  • allows upgrade option for existing manual work-stations
  • effortless bit exchange
  • cycle time optimized

The DEPRAG Feed Module (DFM) enables screw assemblies on screw positions which are difficult to access (e.g. round housing forms), by using vacuum assistance.

Screws or nuts can be positioned mechanically and set-in-place by using vacuum suction. The operator can therefore access even hard-to-reach screw positions without any problems. Independent from the operator, the integrated stroke-mechanics uses cylinders to control the precise pressure required for the positioning element.

The best solution

  • for recessed screw positions
  • for nut assemblies
  • for pressure control (prevent damage to parts)

Optionally available: rotating hand grip for components which require differing jaw-openings of the nosepiece.

LED status display (red/green) on the hand grip: Direct status feedback in the operator's line of sight.

Clamping cartridge for all DEPRAG stands and gantries ensures ease of operation without annoying pressure reaction force.

Programmable pressure control
For screwdriving tasks with differing pressure requirements during a single assembly task.

The DEPRAG Feed Module can be combined with an EC-Servo-, EC- or pneumatic screwdriver with mechanical shut-off clutch, a DEPRAG feeding system, linear stand, position control stand, linear gantry and position control gantry.

For recessed screw positions

For nut assemblies

For pressure control